programing keyless remote for a 04 GMC Envoy

[BJones21]

what are the steps of programming a keyless remote for a 04 gmc envoy

--
Message posted using http://www.talkaboutautos.com/group/alt.autos.gm/
More information at http://www.talkaboutautos.com/faq.html

[80 Knight]

Post by BJones21
what are the steps of programming a keyless remote for a 04 gmc envoy

1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver's door panel-continue to
hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without
starting the engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock
and unlock the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously
until the door locks and unlocks. This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any
existing transmitters).
12. Turn the ignition switch to the ON position in order to exit the
transmitter programming mode.

[warrenry]

We have and 04 Suburban. Will this work for the Suburban. Thanks.


Warren

[80 Knight]

Post by warrenry
We have and 04 Suburban. Will this work for the Suburban. Thanks.

2004 Chevy Suburban

1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver's door
panel-continue to hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go
without starting the engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will
lock and unlock the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously
until the door locks and unlocks.
This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any
existing transmitters).
12. Turn the ignition switch to the ON position in order to exit the
transmitter programming mode.

www.programyourremote.com

[t***@gmail.com]

Post by BJones21
what are the steps of programming a keyless remote for a 04 gmc envoy
--
Message posted using http://www.talkaboutautos.com/group/alt.autos.gm/
More information at http://www.talkaboutautos.com/faq.html

still not working, Any other suggestions?