Document ID# 926127
2004 Pontiac Grand Prix
--------------------------------------------------------------------------------
Powertrain Control Module (PCM) Replacement
Service of the powertrain control module (PCM) should normally consist of
either replacement of the PCM or electrically erasable programmable read
only memory (EEPROM) programming. If the diagnostic procedures call for PCM
replacement, inspect the PCM first to see if the replacement is the correct
part. If the PCM is faulty, remove the PCM and install the new service PCM.
The new service PCM will not be programmed. You must program the new PCM.
DTC P0602 indicates the EEPROM is not programmed or has malfunctioned.
Notice
Do not touch the connector pins or soldered components on the circuit board
in order to prevent possible electrostatic discharge (ESD) damage to the
PCM.
Notice
Turn the ignition OFF when installing or removing the PCM connectors and
disconnecting or reconnecting the power to the PCM (battery cable, PCM
pigtail, PCM fuse, jumper cables, etc.) in order to prevent internal PCM
damage.
Removal Procedure
Important
It is necessary to record the remaining engine oil life. If the replacement
module is not programed with the remaining engine oil life, the engine oil
life will default to 100%. If the replacement module is not programmed with
the remaining engine oil life, the engine oil will need to be changed at
5000 km (3,000 mi) from the last engine oil change.
Using a scan tool, retrieve the percentage of remaining engine oil. Record
the remaining engine oil life.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnect/Connect Procedure in Engine Electrical.
Remove the left front inner fender brace. Refer to Brace Replacement - Front
Fender Upper Diagonal in Body Front End.
Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct
Replacement .
Remove the air cleaner housing cover screws (2).
Remove the air cleaner housing cover (1).
Without disconnecting the PCM electrical connectors, remove the PCM and the
wiring harness from the air cleaner housing assembly (3).
Disconnect the PCM electrical connectors and remove the PCM (4).
Post by t***@gmail.comI'm installing a navigation radio in my 2004 Pontiac Grand Prix GT and
cannot find my ECM. Can someone PLEASE tell me where it's located?
Thanks!
Thomas