adjusting rocker arms on 3.4L V6

[Stephen]

I recently replaced the head gaskets on my 97 Chevy Venture (3.4L V6).
When I put the rocker arms back on, I torqued them down per the
instructions in my Haynes manual. At the time I was concerned because
some of the rocker arms seemed looser than others. When I started the
van, I could hear a clacking sound. My uncle tells me I need to find
out how to do a "valve lash" adjustment. What steps should I take
when installing the rocker arms in this engine?

Thanks,
-Stephen Smith

[Rich B]

This post might be inappropriate. Click to display it.

[Lenny]

Check it out steven, before you try to tell people exactly what it is you know nothing about, go read a book. 3.4l v6 Chevy only have 1 size push rod for all the valves. Don't be giving people false info unless you do your homework first. Ok school is in session I suggest you atten

[Winnie86]

Hey Lenny Boy. Before putting Steven down, make sure you know what you are talking about. I got the push rods from my Chevy 3.4 liter V6 in my hand right now. They are NOT all one size. Try actually working on the engine before saying anything about it

[shiden_Kai]

Post by Stephen
I recently replaced the head gaskets on my 97 Chevy Venture (3.4L V6).
When I put the rocker arms back on, I torqued them down per the
instructions in my Haynes manual. At the time I was concerned because
some of the rocker arms seemed looser than others. When I started the
van, I could hear a clacking sound. My uncle tells me I need to find
out how to do a "valve lash" adjustment. What steps should I take
when installing the rocker arms in this engine?

There is no "valve lash" adjustment on these engines. One of two
things has happened. Perhaps 3 things. One, you mixed up the
short and long pushrods (short pushrods go on the intake valves,
long on the exhaust valves). If you did do this...and you run the
engine for any length of time, you can do some major damage to
the engine.

Two, you didn't get the rocker arm pedestal down into the cylinder
head properly (both the head and rocker arm pedestal are notched,
cylinder head is the female side, pedestal is the male side) and so
even though you have the rocker arm torqued down, it's not actually
all the way down.

Three, sometimes, it's completely normal for the lifters to either
pump right up and when you start the vehicle, it seems as though
there is no compression, or they "won't" pump up right away, and
you end up with lifter noise until the engine warms up a bit. This is
usually due to the coolant that has been running around in the engine
oil. Dexcool makes a scummy brown sticky coating that gets all
over the inside of the engine and the internal parts of the engine.

Hopefully for you, it's either 2 or 3.

Ian