This should be it:
To program a transmitter, there are 3 modes within the remote control door
lock receiver.
Add mode: This mode is used for adding new or additional transmitters.
Rewrite mode: This mode is used to erase all of the previously programmed
transmitters and should be used when installing a new receiver.
Confirmation mode: This mode is for confirming how many existing
transmitters are registered before adding any transmitters.
To begin programming, follow the procedure.
Set the following conditions:
Ignition off and ignition key out of cylinder.
All doors closed except drivers door.
All doors unlocked.
Insert the ignition key into the key cylinder momentarily and remove it.
Using the switch in the drivers door, move the switch to LOCK-UNLOCK 5 times
at approximately 1 second intervals within 40 seconds.
Close the drivers door, then open it.
Again, move the switch to LOCK-UNLOCK 5 times at approximately 1 second
intervals within 40 seconds.
Insert the ignition key into the key cylinder.
Turn the ignition switch from ON-LOCK at approximately 1 second intervals
for 1-3 times according to the desired mode.
1 time for add mode
2 times for rewrite mode
3 times for confirmation mode
Remove the ignition key from the key cylinder.
If the add or rewite mode has been selected, the doors will lock-unlock once
or twice at 1 second intervals, once for add mode or twice for rewrite mode.
If the confirmation mode is selected, the doors will lock-unlock 0-4 times
at 2 second intervals to inform the technician of the number of transmitters
programmed.
Press a transmitter button for 2 seconds. The doors will lock-unlock once at
a 1 second interval to inform the technician that the signal has been
received from the transmitter.
Close the drivers door, then open it.
Press a transmitter button for 2 seconds. The doors will lock-unlock once at
a 1 second interval to inform the technician that the signal has been
received from the transmitter.
If the doors lock-unlock once, the transmitter programming has been
completed. Go to step 9 to continue programming for additional transmitters.
If the doors lock-unlock twice, the transmitter programming is not complete.
Go to step 9 to begin the transmitter programming again.
--
Robert Hancock Saskatoon, SK, Canada
To email, remove "nospam" from ***@nospamshaw.ca
Home Page: http://www.roberthancock.com/
Post by Just MeDoes anyone know how to program the keyless remotes on a 2001 Chevy Prizm?
Or possibly a Toyota Corolla since they are essentially the same car?
Any help would be greatly appreciated!
----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeed.com The #1 Newsgroup Service in the World! >100,000 Newsgroups
---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---